XPS 300
Extruded Polystyrene

THERMAL GOLD
THERMAL BLUE
*GST Inclusive
We offer VOLUME DISCOUNTS!
​
EPS x XPS - Physical Properties Comparison
.png)
​
XPS Extruded Polystyrene Insulation Panels Australia
​
REDBAK – THERMAL GOLD XPS Extruded Polystyrene products are manufactured using German Extrusion Technology.
​
At all times our products are manufactured using only 100% virgin resin raw materials…no recycled resin materials are used in the manufacturing of our XPS products. Thus, ensuring the longevity of the insulating performance within our products.
Whereas many Australian and overseas XPS Extruded Polystyrene manufacturers only use 70% virgin resin raw materials and blend in 30% recycled re-ground resin materials.
THERMAL GOLD XPS - Australia’s largest XPS Sheet: 2950 x 1200mm
Our Diamond Embossment… top and bottom surfaces ensure better bonding strength to other surfaces.
​
Our Shiplap profile edges on both 2950mm sides ensure better fitment strength and watertight bonding of all XPS Extruded Polystyrene sheets at the job site.
Extruded Polystyrene is a closed-cell foam insulation material, approximately 93% of its weight is polystyrene, while a small percentage also contains improvement admixtures, pigments, and B1 - Flame Retardants.
XPS Extruded Polystyrene crystals are blended with special additives and eco-friendly blowing agents, creating a thick mixture. This mixture is then homogenized under automated and perfectly controlled conditions of temperature and pressure.
​
​REDBAK - XPS Extruded Polystyrene - Thermal Insulation XPS with 100% virgin resin raw materials will maintain its proven high - performance characteristics over 50+ years. Its strengths speak for itself, having a uniform closed-cell rigid structure with virtual zero voids/pathways for moisture to enter, offering high compressive strength with lower thermal conductivity, dimensional stability, and resistance to below ground decay.
​
REDBAK Thermal Gold and Blue XPS have been manufactured with B1 Grade (Difficult to Ignite) Fire Retardant additives and always with 100% Virgin Raw Materials (no re-grind materials are allowed).
​
We are Servicing Customers from Victoria, Melbourne, Surfcoast & nearby areas.
​
Our products have been Fire Tested by SGS
Report No: SHCCM150501437
Date: May 19-2015 to August 05-2015 to the following Standards:
EN 13823:2010 and EN ISO 11925-2:2010
